NITROUS STAINLESS STEEL LINE INSTALLATION TIPS & FACTS
STAINLESS STEEL LINES MADE BY RUSSELL PERFORMANCE
When installing Russell nitrous stainless steel lines many important factors come into play to ensure a proper and satisfactory installation. On this page you will see some basic install help scenarios to guarantee your lines are being installed properly. Please view the male AN adapter identification charts, B-nut size charts, and thread pitch charts bellow if unsure about a specific nut or adapter size.
|
 |
HOSE INSTALLATION TIPS
 |
 |
 |
|
Avoid installing the hose in a twisted position to prevent unwanted stress in the hose. |
When routing the hose assembly provide a smooth bend radius. Avoid sharp bends, it will collapse the hose I.D., restricting flow. |
Allow slack in your hose assembly for changes in length that occur under pressure. |
|
MALE AND ADAPTER IDENTIFICATION CHART
The line drawings underneath depict actual sizes of the various common AN thread sizes by dash number. Please print out this page at 100% then lay your fitting over the appropriate drawing to determine what size fitting you have or need.
|
B-NUT SIZE CHART
The line drawings underneath depict actual sizes of the various common types of fittings, hose ends, and adapters. The numbers in the parenthesis are SAE wrench size equivalent. Please print out this page at 100% then lay your fitting over the appropriate drawing to determine what size fitting you have or need.
|
PIPE THREAD SIZE CHART
Use the diagram to the right to find pipe thread size. Please print out this page at 100% and place fitting against Base Line; read fitting size where it intersects the vertical line.
|
|
Features and Benefits
Accessories
