BRAKE & CLUTCH HOSES - Install Tips & Facts

RUSSELL BRAKE BLEEDER INSTALL TIPS & FACTS
ONE PERSON SYSTEM TAKES THE WORK OUT OF BLEEDING
Bleeding your brake or clutch hose has never been easier or simpler! Revolutionary double-patented Speed Bleeder replaces the original bleeder valve in your caliper/wheel cylinder with a spring-loaded one-way ball and check valve design. This unique design opens to allow the old fluid and air out, then closes automatically between pumps to prevent the old fluid and air from re-entering the hose. It's a real time saver!
SPEED BLEEDER INSTRUCTIONS
Step One: Open Russell Speed Bleeder screw 1/4 to 1/2 turn. Attach hose to Speed Bleeder bag or catch can to collect brake fluid.
Step Two: Pump brakes until air is purged from wheel cylinder. No need to close the screw between pumps as with a stock brake bleeder screw.
Step Three: Close valve. Repeat previous steps for other wheels, adding brake fluid to master cylinder as needed to maintain level.



SPEED BLEEDER IDENTIFICATION CHART
The Hose drawings underneath depict actual sizes of the various common AN thread sizes by dash number. Please print out this page then lay your fitting over the appropriate drawing to determine what size fitting you have or need.


Sign Up To Receive Our Newsletter & Members Only Specials  
Privacy Policy | Order A Catalog | Warranty Information| Site Map
©2009 Edelbrock Corporation