Pro-Flo2 EFI System Features
System Features
Original Pro-Flo
Pro-Flo
Generation 2
Complete package includes: intake, fuel rails, throttle
body, ecu, harness, fuel pump, fuel hose, fuel filter, all
sensors and hardware
X
X
Semi-sequential Injection (paired cylinder injector firing)
X
-
Full-sequential Injection (individual injector firing)
-
X
ECU requires base calibration chip (EPROM)
X
-
ECU is flash-programmable (no chip) and includes base
calibrations
-
X
Unlimited calibration storage (PC based software only)
-
X
Tune with handheld calibration module (can save and
restore up to 3 base maps)
X
X
Laptop tune with PC software and on-screen userfriendly
interface
-
X
Map-N (speed density) tuning strategy; references
Engine speed (RPM) against MAP (Manifold Absolute
Pressure) to determine fuel and spark requirements.
X
X
Alpha-N (speed throttle) tuning strategy; references
Engine speed (RPM) against Throttle position to
determine fuel and spark requirements.
-
X
4x6 fuel table / 3x6 spark table (Using Cal Module)
X
X
11 x 16 Load and RPM tables if using PC software
-
X
Closed loop fuel control
X
X
Real-time tuning (Pro-Tuner requires program to be
saved and cycled for ECU flash)
X
X
Adjustable Rev-limiter
X
X
O2 Sensor: Includes narrow-band O2 sensor and will
accept wide band. Wide band sensor not included.
X
X
MAP Sensor: includes 1-bar. Will accept 2-bar or 3-bar.
X
X
Idle Motor: Pulse width (2-wire) idle motor
X
X
NOTES
Original Pro-
Flo being
replaced by
Pro-Flo GEN
2
Requires use
of PC for first
time base
calibration
selection.
 

Edelbrock Corporation · 2700 California Street · Torrance CA. · 90503 · 310.781.2222