Edelbrock Performer RPM Series Manifolds For Pontiac

PONTIAC 326-455 V8
Designed for 1965-79 street 326-455 c.i.d. Pontiac V8's (except Ram Air V and 265/301 V8's). Pontiac intake manifolds provide maximum high-rpm power while maintaining good throttle response for street. Recommended for high-performance street, strip and marine. Has clearance for HEI distributor. Will not fit under Trans Am Shaker hood without modifications. Also available as a complete manifold and carb kit.
Pontiac Performer RPM Series Intake Manifolds by Edelbrock
Application Dyno Emissions Satin Polished EnduraShine
Performer RPM Pontiac (non-EGR) 7156 71561 † 71564
Special order non-returnable product, please allow 4-6 weeks for delivery.
Edelbrock Carburetor Recommendation CARB RECOMMENDATIONS: Edelbrock Thunder Series AVS or Performer Series (650-800 cfm) Carburetor.
Edelbrock Installation Note INSTALLATION NOTE: Recommended intake gasket: Edelbrock #7280. No provisions for OEM choke. OEM carb requires conversion to electric/manual choke. For 1968-71 use #8015 throttle bracket. Manifold height: 1-1/4" taller than stock, A-6.88", B-8.00" measured to engine block; Carb pad height: 7.45". Port exit dimensions: 1.10" x 2.06". For the heights of all Edelbrock manifolds, please visit the the Manifold Reference Dimensions page.
Edelbrock Camshaft Recommendation CAMSHAFT RECOMMENDATIONS: Performer RPM #7157. See Camshaft section for cam card specifications.

The following guide is designed to help you determine which Edelbrock components are legal for use on your vehicle. Learn more about Edelbrock Product Emissions Guide.

    50-State Legal
    For Racing Use ONLY
    For Use on Pre-Pollution Controlled Vehicles (PPCV)
    Stock Replacement Part
    Engine Swaps